MOWOK Fit For Goldwing GL1800 2002-2017 and 2018-2024 Goldwing GL1800 1800 Motorcycle Side Stand Extension Kickstand foot Pad (Year 2018-2024 (Black))

I saw another Goldwing have this kickstand pad. I just had to get one. My Goldwing looks great when parked with this pad installed. I only wish the company would provide the metric tools to tighten them. I had to buy a set of metric. All Goldwings needs a pad like this.

Cheap side stand foot, looks really goo and perfect fit. I used blue thread locker on screws. Time will tell how it holds up. FAST shipping.

Did not receive this part. Send, paid, etc. Post said reported stolen. Beware of ordering from other than Amazon.

I installed this on my 2016 Honda Goldwing GL 1800 …easy fit… Now I don’t have to worry when I put my Goldwing on the side stand . It will not sink in the dirt or loose gravel.

The product is sturdy and fits perfectly. Unfortunately the set screw vibrated out during the first ride. It was replaced with a metric bolt and that solved the trouble. I would recommend this product but would also use another set screw.

I purchased this to increase the footprint of my side kickstand on my 2005 Honda Goldwing 1800.This pad was easy to install. To minimize the screws from vibrating loose, I used thread lock on all the screws, including the set screw on the side.

I park a lot in Grass , this makes my foot a lot bigger so it doesn't sink ...

looks great and locks down tight. use thread locker.this is actually 2 pieces. the colored top piece bolts down over the top of the stand and secures it to the foot. there is a set screw in the base to center the stand.

Product looks beautiful, came with a small circular rubber pad which I wasn’t sure where it went since it doesn’t come with instructions. I installed the foot onto my stand without it. Tighten screws down by hand and then lightly to contact with an Allen key, seemed ok, ever so tiny bit of play so I loosened the screws and placed the rubber pad between the bottom of the kickstand and the top of the plate, the top bracket now seemed too high to fit. I started tightening the screws down slowly but they get to a point where head strips, won’t tighten anymore. All three screw heads stripped. I tried to remove the screws, won’t come out either, stripped in both directions. The top bracket isn’t quite making full contact with the bottom plate… was the round pad not supposed to go where I put it? I can’t decide if it’s cheap screws, pad in wrong place, poor engineering of the bracket, or whether screws are meant to strip at a certain torque spec to prevent stripping the machined aluminum bracket??? Too late to return to Amazon.ca so I’m stuck. Either I ride with it and accept that it’ll fall off at some point, or drill the screws out and hope I don’t damage the bracket threads, then go buy better screws. For the price I paid, I expected better quality and instructions.