Ogrmar Plastic Dustproof IP65 Junction Box DIY Case Enclosure 8x8x5.2 | Plastic Junction Box with Surface Mount Design, Durable Housing, Easy Installation for Electrical Wire & Cable Protection

Very stout and well made box. Feels very high quality --- you'll believe it could survive a typical "garage" impact without difficulty. Worked great for my installation of a level 2 EV charger in my garage. Worth every penny.

Shipping was very fast. Price was very reasonable. Well made. Will use this project box to make a portable power supply. No complaints.

Nice sturdy box . Used it on the surface grinder in the shop. Mounted right to frame, small enough to not get in the way.

This is a nice PVC box and will work well for consolidating my two solar strings before entering the disconnect switch. My only issue is the plastic cover screws, they may be the weak point. Avoid over tightening them and should last a long time. There are no KOs, so placement should be easy with a Uni-Bit step drill.

Used this plastic box to create an electrical box for my boat. It was easy to modify and fit the application perfect. I was able to cut the plastic to install switches and put all wire connections inside this box

The build quality seems good and I liked the design allowance for the 6 screw holes that are completely isolated from the box built so there won't be any water leak into the box from the screw holes. It does not come with any openings on the box which was my preference as I had odd sizes to drill. I had to drill three openings with a hole drill bit and the cuts were nice with no shattering or cracks as a result which I have seen some people complain on some other boxes. It also comes with a water tight rubber sealant to secure the lid to the box. I am satisfied with the box and its quality as a whole, the price seems a bit too much for a simple box.

No Problem

This in an excellent project or junction box. The most impressive aspect is the use of machine screws and brass inserts for the lid instead of the typical wood/plastic screws. It should survive repeated opening/closures. The downside is the backside to the screws are open and thus requires antiseize if used outdoors. The gasket does not come installed but fortunately is supplied with 2” additional material so there is no worry regarding proper fitting. Just push the gasket into the lid and trim the excess. The thickness is greater than most project boxes but significantly thinner than a plastic nema box. Internal plastic standoffs are of questionable usefulness unless you design around this enclosure. Each corner eats 1/2” off the long axis and 7/8” off the short. It overall exceeded my expectations.

Good enclosure

Wonderful !

Product was as described.