KEMIMOTO Motorcycle Turn Signals Light, 4782LM Upgraded Bright LED - 2PCS

Very bright and nice looking lights, look like the ones that are Oem on some bikes.

Love these. They are bright and small but not to small. They pulse from the inside to the outside. I 3d printed mounts so they would fit the oem mounts of my Indian FTR1200. No resister needed for my FTR.

They were smaller than I expected but I guess I should have paid more attention. That said, once I had them installed, they looked right. I installed on a 2024 hawk 250 DLX. The install was simple enough. I had read that I might need a different flasher but didn’t end up using it. They are very bright and the sequential flash more than makes up for the small size. Couple words of caution…. Don’t tighten down too much or the threaded part will pull right out of the light. I learned the hard way on the first one. I was able to fix it with some hot glue on the threads and crammed it back in. After that I used blue loc-tite and just snugged them down. You could double nut them too. The wires for the back lights were short for my bike so I had to add on. Front were plug and play. Would have been 5 stars of the threads didn’t pull out.

A little smaller than I expected, but that's on me. Other than that, they look and work great... good product from a good company...

Simple to install, very bright

I’ve been very happy with the kemimoto items I’ve ordered so far. They seem to be of higher quality than similar products. These signals are no different - bright leds with an attention grabbing chaser flash. The stalks are slightly flexible which is nice for longevity. Dropped to 3 stars after 1 year of use: As some other reviews have stated, the threads pull out of the plastic housing and cannot be repaired. I tried using gorilla glue to reinsert it but it just can’t handle much tightening pressure. These work well IF you are pretty gentle on the tightening force. I ordered another set to replace the one that pulled out, so would I. It again - yes. Just be careful with how hard you wrench on it.

Got these to replace some cheesy cheapo signals on a used Ducati Monster I bought. They’re quite bright and not just in lower light conditions. Just use a jam nut if you’re gonna go ape on torquing the fasteners. It really doesn’t take much torque to hold them in place. I did use a lock jam nut on the rear ones. That is, I snugged up the nut that came with the signals and then threaded on a locking nut to jam against that nut to keep it from vibrating loose. I installed them front & rear even though I have an integrated turn signal tail light. I was impressed and pleased enough with the fronts that I went ahead and installed the rear ones too. For the money I think they’re quite a good value and are substantial in build quality “feel”. IE they don’t look or feel cheap. These are my second purchase of Kemimoto branded products and I’ve not been disappointed with either.

They look ok. They are small. They are trash. When you tighten the nut the threads pull out of the plastic before they get tight enough to not move when you ride. No excessive force was used. They just pull the threads right out of the housing.

Worked great to replace the old signals on my older bike. Stems (threaded bolt portion) were true to the indicated 8mm size and fit the stock mounts on my bike (Buell). Most aftermarket signals seem to be 10mm or more. I agree with the earlier review that says they are small but plenty bright. The sequential pattern is modern and does look great!

After less than one week on of the two flasher got water stock in it and damaged the led bulbs and lens