13-Pin Trailer Tail Light - Reverse Stop Sequential Turn Signal Running License Plate Light Combination Taillights for Truck Trailer RV Camper, E-mark Approved

once fitted these are very good, well made and bright.However I believe that there has been an error in the manufacturing, the instructions which came with the lights show a plug connecting each light to the main wiring loom. there are no plugs on the product which makes mounting the lights extremely difficult. It would be much easier with plugs or making the dividing block easy to take apart the wires are encapsulated in plastic or something which would make it a difficult job.I am overall pleased with the purchase so far, but I am not a typical user and the aesthetics were not important on my trailer

Picked up an old trailer recently with very old lights and wiring that don’t work. So decided to replace them with this set. Very easy to install. Comes wired and ready to install out the box. Nice a bright lights including everything you need to be legal.Lights are of a good quality with good quality lenses which should last a long time. Wiring also appears to be a good quality.Highly recommend if you are looking to install new lights to an older trailer.

Worked first day, then second day it rained and they started to play up. now both indicators don’t work obviously not sealed correctly 👎🏼

I purchased these lights for use with a rear tow ball carrier which strangely does not come with lights as standard.I have a UK spec VW with factory tow bar and factory 13 pin electrics.The lights look great, they are very bright and the dynamic indicators work in sync with my car’s dynamic indicators. All of the lights are working fine, and the quality of the units appear very good.However, even though the lights are working fine, they are throwing up various (very annoying) light faults on the dashboard i.e: ‘check brake light’, ‘check left side light’. Having researched this issue, this is probably caused by the lower voltage of the LEDs. There is a CANbus 13 pin to 13 pin adapter that can be purchased to eliminate the fault lights but the cheapest is £74.If used on an older car, they will probably work without any dashboard faults.As a result, I have taken a ⭐️ away from this review.

Whilst the quality of the lights are not in question all the wiring is sealed and moulded. Which means if you are replacing lights you need to cut the wires to install! A really basic addition would make all the difference! Frustrating install…..

Well presentedQuality outstanding, well made and built to last, works well and as it should do.Really handy in lots of circumstances and useful to have as a back up.Would buy again.