VioGi 1pc New Front HVAC AC Heater Blower Motor With Wheel Fan Cage Fit 1997-1999 Chevrolet/GMC C1500/C2500/C3500 K1500/K2500/K3500 Suburban Tahoe Yukon 2000

Works well.

It works good, easy to install. I had a minor problem with the ground terminal which was easy to cure. The original ground terminal was connected using a screw type bolt. This replacement had a stud post for the ground terminal spade. I was lucky I had a #8 nut to use and tighten the terminal. Only complaint is it should have come with the nut. The stud post is very short and no room to put lock washer on. Installed on 97 K1500 and no trimming needed, perfect fit.

Fit was perfect all speeds work well,fast shipping, item as described. Was easy to replace

Low price, quick delivery and it works.

The blower motor looks well made until you see that all the screw holes are in the wrong place and the hole on the motor that the small 90deg hose from the housing to the motor is lined up with the power terminal, other than that it works great just requires a little unneeded hole tapping but anything from Amazon is pretty much like rolling dice.

What I liked about this was that it was spec'd for my vehicle (99 chevy suburban) and the price compared to similar models that do the same thing but was priced higher. Now when it arrived, I noticed they didn't install a negative blade on it near the positive blade. There was a screw if you wanted to install a negative wire, but some moron installed it the wrong way (at manufacturing) and the phillips side could not be obtained because it was fan facing underneath the fan wheel. So that was out of the question and an alternative means was necessary. I had to create a new location with a nut and screw to install a negative wire. Once I installed the blower motor, I observed air seeping from the left side, although there was a included flimsy gasket on there, I thought it was not performing to the manufacturers standards, so I had to uninstall the blower motor and remove the included gasket seal to install the old one from the non-working blower motor and reinstalled it. It worked a little bit better, however, the blower motor did not sit completely in the hole the original one came out of on the left side. It was like it was off centered half an inch. I may have to inject foam sealant to close the gap. Other than that, It took a bit to warm up and get the heater hot to blow hot air, but then again it was 22 degrees when I installed it.

Works great

easy installation seems to be working fine

يحتاج الى نقل الموصل الأرضي من المروحة القديمة