CoverTec GlazeGuard High Gloss Tile & Grout Sealer | 2-Part A+B | 1 Gal

This added a beautiful finish to unglazed tiles we put up as a backsplash. Product was easy to use and makes tile much easier to clean and looks amazing.

No complaints or issue’s. Sealed my non-glazed tiles with a nice glossy shine. Just invest in a plastic measurement cup to mix the solutions and follow the 3:1 ratio.

This sealer is awesome!!! Made my new tile look even more beautiful!! Goes on milky then dries clear looks perfect… I used 4 inch roller. Easier to get into the grout lines. I highly recommend this product!! if you have leftover do not pour it back in the bottle and seal it! it started to expand luckily I noticed….!!!

This product is terrible. Do not buy it! First, there are no instructions on the bottle, which is unacceptable for a product like this. The bottle is also extremely small, and the QR code that is supposed to provide instructions doesn’t even work. The biggest problem is that once you mix the two solutions, the product becomes completely unusable the next day because it hardens in the container. There is no warning about this on the packaging. To make matters worse, after applying the sealer, the tile surface remained sticky, which is the exact opposite of what I expected. Overall, this was a complete waste of money and a very frustrating experience. I wish the manufacturer would provide clear instructions and improve the quality of the product!! I want my money back.

This stuff is amazing, I have waited to write a review because I wanted to see how it holds up. It has been about 2 years since I applied this coating to my tile floor in my main hallway and bathroom and it looks as good as it did the day I applied the coating. I have had a new washer and dryer brought in using a dolly and furniture has been dragged across this floor multiple times. I also have 3 large dogs around 50 pounds each and this is a main hallway between all the bedrooms and it has held up amazing. There isn't a single scratch on this coating from any of the abuse that it has endured. The only thing I have to say about applying this is to make sure the surface is spotless before applying it and do not let anyone near it for several hours after it has been applied. If anything falls on this coating prior to the curing process being complete like a hair or anything, it will be there permanently unless you want to sand it out and re-apply the coating to that area. This is not a fault of the product obviously. There is hardly any smell from this coating while applying it either so fumes do not seem to be an issue and any tools used during the application are easily cleaned up with warm soapy water. This stuff is absolutely amazing and I would recommend this to anyone that wants to apply a protectant water proof barrier to any of the compatible surfaces.

I prepared my floor and followed step by step instructions. So far, it looks great. If it wears well, I will be very happy with it.

The product went on easily and looks great. The only negative is that a wine spill seems to have completely removed the covering. Maybe it just dissolves in alcohol.

Let me start by saying, we absolutely love the way this product looks- it seems to be very durable and gives that nice "wet" look- like others, when we have had friends over, they asked if the tile was safe to walk on! We were a little concerned with how slippery the finish would be underfoot, but it is absolutely not a concern. Easy to clean, and made the grout look like the company said it should from the start (It lightened up several shades after it initially dried). Makes cleaning the grout a snap as well- much, much better than a standalone grout sealer when I've used in the past. There is a learning curve for application- you'll need to plan out your time carefully, especially if it's getting applied in an area like a kitchen and main room like we did, as it takes 12 hours+ to cure. That time is absolutely impacted by temperature, so if you have your furnace set to go down lower than that in the winter overnight, you could wake up to the floors still being tacky in the morning like we did. Fortunately it wasn't a bit deal and walking on it didn't leave permanent marks. Make sure you have really good lighting when you apply it- which can be a challenge at night if you're trying to do it before bed- our initial pass had a few spots that we missed- and be meticulous about things like dog hair- we vaccumed and mopped, but still have a few floaters that wound up here and there- we're the only ones that notice, but still. If you do have spots you missed, be sure to sand the whole tile when you are re-applying- turns out far better. We tried the 400 grit at first that the seller recommended when I called him, but it didn't make much of a dent. Did some reading on their website and saw that 150 grit would work as well, and found that to be a much faster and better solution- makes it look hazy obviously, but when you apply the new coat it shines right back up. We'd absolutely do it again- really, really good product. Hopefully it holds up for years to come.

The tiles used had a matte finish and were hard to clean. We bought matt tiles for the floor because we wanted a non-slip surface in the shower area, but we did not anticipate the cleaning problem. Glaze Guard has sealed the floor. However being a novice with GlazeGuard, we did discover that the thickness of the application is important, so my application was a bit uneven in a few places, so I will have to touch it up in some areas.

if you prep the tile, i used it on a porcelin tile, the results are amazing. I had laid a wood grain porcelin tile in black. It always looks dirty, because there was very little shine to the tile. When it was wet, omg!! it looked pheminenal. Bought this product after seeing it on you tube, I was a bit skeptical, i tried it out on a piece of the flooring that i cut down for a border. The results convinced me that this was what i was looking for. My only negative is that it scuffs easily. I put down cardboard on the floor to protect it while i re-installed my stove. I thought that since the fridge had wheels, i shouldnt have a problem.. When i turned the fridge into the space, it left some scuff marks. Going to try and re-apply some of the glaze and see if it will cover.

I do not recommend this product. I applied it as per the instructions and within a month it began peeling.

Purchased a few times now Fairly easy to apply allow sufficient drying time Preparation is essential remove all dust dirt debris and previous sealant etc as this prevents peeling or poor finish Used this before , then after trying another brand realised how good the finish was with this product 4 stars as this can peel ,prep and care are key here however compared to others which didn’t last or protect the floor for very long or give a good finish . Wash with fairy liquid and water not floor cleaner or any other products this prevents peeling also Overall the best I found Not many sealers can be used on ceramic / porcelain tiles and this is the only one that works

Product peeled on tile and made a total mess of the job. Two kinds of tile.