Mixer Worm Gear Kit Compatible with Kitchenaid Whirlpool 5qt 6qt Mixer Gear Parts Replacement,9706529 9709511 9703337 9709231 Worm Follower Gear Kit

We originally purchased this mixer around 2016. We put in the new parts today and tried it out and it appears to be working great. This mixer has made a lot of cakes over the years and we didn’t want to throw away a perfectly good and expensive mixer. However, this particular model mixer was discontinued in 2024. Our concern would be access to replacement parts going forward. Thank you.

The gears only lasted for a few months

Decided on this kit after reading reviews, I didn't see complaints about noise like I did with other similar kits. My mixer was quieter than when first purchased after it ran for a minute or two. These gears seemed as hard as the originals so they should last as long, that would be about 20 years of pretty good service, we ran a small catering business for a while so it got a workout for those years. The kit had everything I needed to replace the gear assembly, with one exception, see the image. You will need to reuse the original shafts and bushings, but mine didn't show signs of wear so I was good with that. Very simple process as long as you note what goes where before you disassemble the original assembly. Only problem I had was my original race and bearings were completely gone, so I had to find videos of the process to see where the bearings went, check out you tube. Be sure to pack plenty of grease to make the gears work better. A lot cheaper than replacing the whole mixer. This kit does not include the one gear used to drive the rotation of the paddle/whisk shaft, this is located under the mixer at the top of that shaft. You need to take the main assembly apart to get to this gear. Mine wasn't worn so it was not an issue for me, but you may want to check yours before ordering. As far as the tools that were included, they are fine for a limited use, but did not fit my original snap ring. The holes on the original snap ring were too small for the pins on the pliers. I would expect that the specs have changed over the years on the snap ring. I would expect to pay $10-$20 for these pliers if I had to purchase them separately so no complaints but worth mentioning. I lost my good set of snap ring pliers so I made due with these by filing down the pins a hair.

Parts were good but the kitchen aid has a factory defect that lets the gear slip and eventually wears the gear out.would not recommended a kitchen aid to anyone that would use it a lot

The gears are great and fit perfectly. The original snap ring is the same as the one included in this kit. The snap ring plier tips are too big to remove or install the snap rings. The kit does not include the bushings which were also damaged on my machine. Overall I'm happy with the purchase.