アイウィス(IWISS) JSTコネクタ用圧着ペンチ ラチェット式 オープンバレル 0.03-0.5mm2 (IWS-3220M)

I needed to crimp approximately 300 JST XH connectors as part of a home automation project. I initially used a non-original universal crimping tool, which completed the task but did not produce results that met my expectations. I also considered purchasing the original JST crimping tool; however, given its high price and my occasional need for such work, it didn’t seem cost-effective. I was pleasantly surprised by the results — both visually and functionally. The connector wings are neatly rounded and securely attached to the wire and insulation. So far, I’ve crimped 16 JST XH connectors with zero failures. Overall, I highly recommend this crimping tool for anyone working with JST XH connectors.

This is a nicely built crimper. I've used crimpers before but not this particular style. Amazon says, "comes with instructions", but not with my copy so I had to do a little trial and error to get good crimps without crushing the pin insert end of the connector. The numbers on my copy of the crimper differ slightly from the Amazon illustration with the largest being 2.0mm instead of the 1.9mm shown. No biggie. The tool has a good ratchet mechanism which is used to hold the connector in place while the wire end is inserted and then the crimp is finished. Makes great crimps. It's coated with some kind of lubricant which stains so be careful no to lay it on your prize tablecloth when taking it out of the protective plastic bag. Wiping it down doesn't help because there's more lubricant in the bag so it's coated again the next time you remove it. You probably don't want it lubricant free, because this lubricant probably contains a corrosion inhibitor to preserve the tool. Very good tool for the price and works well, but when crimping, be sure to check the insertion distance so the actual connector doesn't get crushed in the process.

Plus petite que je n'imaginais, mais conforme. A l'air solide et précise. A tester en condition réelle.

Köpte den till JST SH men behövde till PicoBlade, visade sig att tången skall passa båda +++

Bought a blue crimper sometime ago and was never successful in crimping connectors without wasting connectors. Especially micro JST connectors, was persistent in trying100connectors and all failed. I almost concluded it is the fault on my part until I bought Iwiss crimper. I was successful with the first try.