iBrightstar IP68 Waterproof Square Trailer Lights kit, Red Brake Stop Tail Running License LED Light Lamp for 12V Camper Truck RV Boat Snowmobile Marine Under 80", DOT Compliant

I had purchased a full light kit and was going to redo all the wiring on my utility trailer when I discovered that the reason I was having trouble with my trailer lights had to do with the ground. Since one of the previous bulbs had burned out, I found that this product worked right away especially after the lights were bonded to the trailer which was very simple to do. There are (3) wires coming off the lights so you should only have to replace the existing trailer tail lights with these and if the rest of the wiring is sound, once the existing electrical connector is connected to your truck or vehicle and the lights in your truck or vehicle are turned on, they should work rather easily. It appears that the lights are perhaps waterproof since I don't see any access to replace the bulbs inside but if you use your trailer infrequently, I expect that they will provide years of service before the bulbs blow. I will probably contact the manufacturer to see if there is a way to replace the bulbs but it may be a better design especially for when they are put on a boat trailer and submerged at a boat launch ramp as it seems like the lights and especially the lenses are practically sealed shut. Time will tell how they hold up but if your trailer wiring looks good but you're having difficulty with the rear lights on the trailer, if you have a voltmeter and find that you have 12 volts available, it turns what could be a all day job into a job that takes less than an hour and doesn't require that you have to crawl under your trailer and reinstall the wiring and other lights. There's often no need to rewire the entire trailer and this saves money as well since you don't end up buying parts that you don't need. Make sure the ground wire is bonded to a piece of metal on your trailer by simply connecting the ground wire from the lights to a screw on the trailer. I'm using my first trailer and I've heard horror stories about replacing trailer lights when I discovered that having the lights connected to the 12V supply but especially having the lights grounded. I was replacing the other rear light but I ran out of daylight so I reinstalled the screws that attached the red rear trailer lights. As soon as the screw attached to a piece of metal on the trailer, the lights started working where I had wasted hours with my voltmeter and other tools on the existing lights but I wasn't getting any power until the screws were installed. I probably could have saved even more money by just buying the burnt out bulb but I liked how well these lights are sealed to prevent water entry.

Great trailer lights easy install..

good product

These lights work as they should.

Functional replacement lights and the pair fit perfectly on 30 year old trailer. Easy DIY project. Replaced rotted wood boards and broken lights on my newly painted old trailer. Great price and water resistant. My trailer looks practically brand new!!! Price plus quality....can highly recommend.

I broke a right tail light on my moto trailer while backing up. Ordered this two light set for the same price that a single light would cost from Harbor Freight. The lights have long wiring leads (6" plus). I now have a spare left side tail light. If I break the right light again, I will sand the clear part of the lens on the "left" side spare light, mask around the clear lens on the underside which illuminates the license plate and paint that 1" x 2.5" clear lens black or red so I can use it on the right side with the painted-over clear portion of the lens at the top : )

Works good

Work well for backup lights. Easy to install and use.

Muy buen producto, a muy buen precio

Hola. Tome un video donde las luces prenden y a los minutos 1 deja de funcionar.

Bright, water proof, good looking Essay to install. But I recommend to ask professional to install it. I only used it for two months with no problems at all.