12.8w/mk Thermal Putty for VGA GPU IC Processor Rapid Cooling Thermal Pad Replacement Heat Blocking Putty High Performance (10g)

Worked great and easy to apply. One unit was enough to replace all the thermal pads from an RX6600.

I recently redid my gigabyte RTX 3090, 2023 zephyrus g14, & a 2020 zephyrus g14. When I was replacing the old thermal compounds, I used this on the memory chips, power delivery, and other ICs that were covered in thermal pad material. This stuff actually provided a little bit lower temperatures than K5 pro. The device I tested the hardest was a 380 and the memory junction temperatures went from 90C (k5 pro down to 78C max.). I used 3d mark to stress test my GPU for 2 hours. I forgot to turn on my portable ac before going to make food. So that max temperature is what was achieved in a bedroom that hit 80°F(26.6C) inside. The gigabyte 380 requires a thicker application because some of the thermal pads 2 or 2.5mm thick. I don't remember the improvements on the two zephyrus laptops, but it was better than the factory stuff. The thermal putty does like to stick to the little stick after sooping a few times, but scraping the stick off back into the container and then re-scooping helps to stop accidentally picking the putty back up off whatever you're applying it to.

Good quality definitely recommend.

You get about 1/4 of the amount in the picture. Used it on the vram when repasting my g14.

"Si eres de los que desarma su laptop gamer o su tarjeta gráfica y se encuentra con esas almohadillas térmicas (pads) resecas y aceitosas, esta masilla es tu salvación. Le doy un 10 rotundo porque soluciona el problema más grande de los pads tradicionales: el grosor perfecto.

It's a good product for thermal pads replacement. It comes in a 2" case with about 1" of putty, 10g. Recommend to place a little putty in-between components to help your thermal paste stick when applying to components. Try not to waste any by putting unused bits back into putty, it'll blend like playdough. Overall worked great and keeps temps down.

Works well. A bit tricky to apply but conforms when you press it down. I applied putty to laptop VRMs and so far haven't experienced crashes in games (compared to Asus stock application). Keep in mind the product picture is for the 50g variant. I used around 80% of the 10g bottle for one laptop (cpu and gpu not included, they had ptm7950).

Used to bridge the gap on the NUC Extreme 13 PCH heatsink and CPU card shroud.

Awesom

Impressive performance

Good thermal putty for laptop VRMS. Use ptm7950 for cpu and graphics card.

Works pretty well. Temps dropped significantly.

104 to 66 --> Vram. But the cost is too high for the quantity.