Rosin Core Solder Wire for Electrical Soldering(0.8mm/50g),

Thin and easily manageable for circuit boards and led strip use. Low melting point and strong connection. This is a great product to use and learn to solder with. Securely holds without difficulty and does not run . Very accurate solder points.

Good solder that doesn't break the bank

It’s really nice to work with. So see comes out nice and clean. I also use it to solder brass parts that I made for my model boat. I’ll buy it again

Very decent solder for the price. It flows well enough, and the flux is very easy to clean with just soap and water.Compared to more expensive 63/37 I have used, it's fine enough. Real good stuff will melt like butter the second it touches the tip of of your iron, and while this stuff is decent, it doesnt quite nail that perfect melt.But it's cheap and you can buy it less than a pound at a time. So I'm going to keep buying it.Solid 8/10 usability.Solid 9/10 price.10/10 clean ability.

My old solder was OLD. I failed to realize until using this solder, that it (the old stuff) either had a high melting point or perhaps because it was so old it took much higher heat to melt than this solder.This solder is easy to melt (around 400F), flows smoothly and holds in place - and most importantly, I suppose, conducts as it should. The small diameter of the wire makes it quite easy to work with in small places.Bottom line: Good price, easy to work with for small points and works well.