SHZOND Bag Air Jack 6600LBS Weight Capacity 3 Bag Pneumatic Jack Handy and Easy Storage Air Jack Lift for Fast Set Up on Frame Machine (3 Bag air Jack)

Great tool fast and effective I use this on my service truck. It takes up less space on the truck , lighter than a floor jack will buy another

I do my own car repairs and have a good quality hydraulic floor jack that I have used for years. However, I'm aging and have shoulder problems so pumping that jack started to be a problem. This jack is easier to roll around and even though a little heavy, unlike my standard 3 ton floor jack, could be considered portable. You could easily put it in your trunk. It only takes about 2 seconds to lift my GMC Yukon or Suburban. Other reviews have stated that you have to replace the air fitting because the original was made for a Chinese sized air hose. Apparently, the manufacturer listened because they also now include a standard 1/4 inch fitting for us Americans. The assembly instructions are almost worthless but there's not much to it. I figure that anyone who has the skill to do their own repair work can figure it out quickly enough. I was able to assemble the unit and start using it within about 10 minutes. There is a minor design improvement not shown in the photos. They have made a slot in the handle so you can run the air tube from the bag up through the handle and then to the fitting. This protects the tube from accidental nicks while being used.

works great and fast to use

Easy to use in my garage

Works great I use it all the time!

Lifting car's that are on a frame machine to put them into the rocker clamps

I like the jack,works as expected but the nut that hols air line in place would not tighten and can't seem to get company to send me another nut and can't find one to replace so just waiting for it to blow off.

I purchased this in order to rotate tires on a 5000 lb vehicle. After assembling the jack and Before I attempted to lift anything I slowly added air to the jack to test the mechanical function of the device I was not impressed with the sounds emitted from it and without any weight on it , it was noisy and reluctant to return to the relaxed position On the first use I slowly raised from the side the rear tire of the car slightly off the ground I noticed that the airbag was starting to lean towards the center of the vehicle, so I slowly let the vehicle back down I had read from another reviewer of the disaster he experienced when the internal stabilization mechanism broke on his jack and I was not waiting to See if I would’ve experienced a similar result. I changed the position of the jack slightly (I am unable to move it too much because the car has very specific lift points) I slowly added the air to raise the vehicle again and it appeared to go straight up and not lean this time. I bought a second jack from another seller and have used the two jacks with one at the front side and one at the rear side to successfully raise the vehicle and subsequently rotated the wheels front to back. I am currently in the market for a good but inexpensive two post lift to be able to raise the whole vehicle at once and I will retire these jacks to working with my less expensive vehicles.I love the convenience of the jacks They are light enough to lift up and roll rather easily At least the first one the Shzond does the second one looks the same but was called Mophon and they manufactured the two tabs that make it stand up differently that causes it to not be able to be lifted as high when rolling and also do a poor job as acting as a stand I was able to purchase both of these jacks for less than half of what one Zendex or RacJac costs but Made in China vs Made in USA