ETL Exhaust Kit fits for 2007-2018 Jeep Wrangler JK Axle-Back Exhaust Kit JK Muffler Exhaust System JK Accessories

This is a direct bolt on to a factory 2016JK. It sounds great but to get the most sound out of it, I put on a cold air intake that really opened up the sound quality. (RiAiCiING Cold Air Intake kit with Heat Shield Fit for 2012-2018 Jeep Wrangler JK 3.6L V6). I sprayed PB blaster on the factory exhaust bolt and around the exhaust connection and let it sit for about 30 minutes. I also sprayed WD40 in the exhaust hangers to loosen them up. The hardest part was getting the passenger side hanger disconnected so I ended up just cutting the bracket off the factory exhaust. Once both hangers were loosed and the bolt loosened from the exhaust connection, it was just a matter of wiggling the muffler left and right and few light taps with a rubber mallet to brake it free. The new exhaust bolted right up and fit great. The major problem I had was putting the tips on. The bracket where the bolt and nut are does not allow enough room to get a socket on it so I had to use an opened wrench and with tiny micro turns I was able to get them tightened on.

All I can say is.. buy this exhaust if you have a JK/JKU! Old exhaust was a PIA to get off but this one goes on with a breeze! I paired this exhaust with a corsa cold air intake and it sounds amazing! At first I was a little disappointed because I like my cars louddd and driving wasn’t as loud as I thought.. until I opened up the back glass on my Wrangler and BAM, sounds absolutely amazingggg! Throaty deep tone, a little crackle when you get on it. Advantage is I have a 6 speed so I can make it growl as much as I want, but I have to say it has a perfect tone between 2500-3000Rpms. No droning that I’ve noticed with my hard top blocking out most of the noise. Going 60-75mph my tires hum louder. I have to say it’s the perfect exhaust if you don’t want to sound like an annoying civic hauling by! HIGHLY RECOMMEND!

Getting the factory exhaust was the “ hardest “ part of this installation. I used some sandpaper to clean up the old exhaust to help slip the new one over. It went on without any trouble. Getting the hangers back it was a little fight but that didn’t take too long either. I a little bit of grease and that helped a lot. I didn’t put the tips on. I didn’t like the way it looked. Too big from the exhaust pipe but that’ll be your choice. I had a really annoying rattle once I started it up and found out the heat shield was vibrating really bad. I ended up just taking it off. The new exhaust is much smaller then the factory and didn’t sit anywhere close to the body of the Jeep. Sounds great for the price! Well worth the money and didn’t take much tome at all!

So far, I'm in love! For the price and a 20 minute install, I couldn't be happier. With that being said, the inlet pipe was slightly bent to where it wouldn't fit. With a little mallet work, some elbow grease, and WD-40, I was able to get it set all the way in on the stock exhaust tubing. I'm going to put that on UPS since the box was damaged in shipping. The growl is great up to about 1400 RPM and the tones out between 1500 and 2000 RPM. No crazy hum, but a great low drone in OD. Have not tested on the interstate yet... I will check the connection for leaks after 30 days, and also test the tip fittings over the next 30.

The system arrived and it was made of good quality, no issues. The install was easy and matched up to the hangers and existing pipe. The sounds is aggressive at start up and acceleration until you get to the cruising speeds and then you don’t hear it as much, which is what I was looking for. I have a soft top so I didn’t want a super aggressive tone as I am driving for a long period of time at cruising speeds. I can’t complain about anything at this point, if anything changes I will update. Great but for a decent price.

In videos and pictures of this product it sounded good and looked great, but now that I've had it on for a while, I regret my purchase, it was a pain to install and had to be modified to sit straight, it made my jeep sound like a Honda civic which was not what I was going for, these are inconvenient but the main problem is the rust, when I initially looked at the product, it said it was made of stainless steel, I've had the exhaust for not even a year and it's almost completely rusted out, i don't recommend buying this, it sucks to say that about a product but I really dont have much good to say about this item.

Way better than stock, perfect level of rumble, beats stock by alot. I am very happy with the purchase

UPDATE: Im having to lower my rating because after 8 months it is already starting to rust super bad. Im gonna haft to replace it after less than a year. Still sounds great but definelty not good steel. Honestly wasnt expecting much outa this but was thoroughly impressed by the sound. Not much drone in thr cabin at all. Sounds mean!! Instalation took around 2 hours but that's cause we didn't have the right tools to take the old muffler off but installing the new muffler took literally 20 minutes and went on super smooth. Fits perfectly! Looks mean and like it belongs on the jeep!

I installed it on my 2012 JK8 , it gives very good sound and it looks perfect. Cheap & good . I love it

Luce muy bien y el sonido es Agaradable hace lo que tiene que hacer lucir bien y escucharce bien

Pour donner une sonorité plus sportive et un look de puissance compatible avec ce genre de véhicule!

Sounds great! Install wasn't the smoothest, old exhaust was a little challenging to pop off. The clamp that came with it was too big. Sounds and looks good all troubles aside.

Tucks up nicely... love the black and sounds mean, but not overly loud. 2018 2dr jeep jk. Get rid if that stock beast muffler