Intek 206 Carburetor 6.5HP Maintenance Kit for Briggs & Stratton Engine Craftsman 798653 791077 696981 Intek 190 Carb 5.5 HP Motor Power Craftsman Tiller Washer Go Kart Engine Generator

This perfectly fits my 2005 Super Bronco Troy-Bilt rototiller with a Briggs & Stratton 6.5HP engine. Really ran rough before, now runs good as new, and my power under load issues (would stall out) are 100% gone. Note that like another reviewer, the enclosed choke controller won't fit through the "hole" in the housing for the air filter. But this package included a "pole" for the choke plate that the original choke controller fits over perfectly, so problem solved. Also the new air filter fits perfectly. Took me an hour from start to finish since I had to remove the guard frame to make it easier to access the carburetor, etc. I did not replace the fuel line. More than likely I will buy another one of these given it's so inexpensive and I know that this one works, because I'll probably have this tiller long enough that this carburetor will need replacing some day down the road.

As described

Purchase the carburator according to the horse power rating of the engine. This one was for 6.5 to 7hp, installed it, connected fuel line, pulled one time, fire rite up.. Ran perfectly no adjustments.Would highly recommend fast delivery, very good price too.

good buy

The carburetor fit my Briggs intek 8.25 used on a tiller. Bolted fine and started first pull. The machine idles, runs full throttle, and responds as to load very well. No adjustments needed.A couple of things to know before you buy. The choke is not assembled, it had 2 different choke plates, to match different engines, it takes 5 seconds to assemble it, just match what your old one had. The choke linkage for my machine didn't fit through the air filter hole, but the original fits perfectly onto the new carb, just reuse that piece. Finally they sent the wrong gasket between the carb and air cleaner, I had a correct one on hand so it didn't delay me any, I messaged them and let them know, after getting some pictures to them they said they will fix the issue and they offered to make it right, A+ for customer service.

A good price for a small engine carburetor. Gaskets and fit were as good as OEM products. Complete ready to run quality carburetor. In my case, no adjustments needed and engine started and ran smoothly. Will purchase again, I recommend this carburetor.

Carb and air filter worked as designed on my Troy Built Super Bronco Tiller. Comes with 2 different valve blades for the choke that will need installed based on the one in the original carb. Fired up on first pull after replacement. Fuel filter is a piece of plastic with no filter media in it. Don't bother installing that. However for the price, I would have no issue if it was the carburetor only

worked like it should