IMPORTANT NOTE: This is developed to fit the recent update Creality made to the S5 aluminum plate with 24 holes. This fits the old version of 4 holes also. Creality may further update this aluminum plate without prior notice. Please kindly check if this one fits your printer before the purchase. Please heat only when after it's mounted onto the build plate (Aluminum plate recommended). A supporting frame/layer is strongly suggested to have the heating element "sandwiched" tightly for better heating result. Any questions, message us. Response within 24 hours guaranteed.
J**R
Awesome heater! Got here pretty fast
Awesome heater! Got here pretty fast. Well packaged. Goes to 60 in under 5 minutes. Heats evenly and once bed is saturated it doesn't cycle on very much. Thermistor is accurate. Great product and thoughtful company. I ordered this SSR uxcell ASH-60DA 3-32VDC to 480VAC 60A Single Phase Solid State DC to AC RelayI did put a fan and heat sink on it but it barely gets hot.And wished that I has ordered some of this but had what I needed form some unused ext cables.BLACK 1/4 100FT BRAIDED EXPANDABLE FLEX SLEEVE WIRING HARNESS LOOM WIRE COVER
A**S
Great product. Makes CR-10 S5 very performant.
Heats up soooo fast. Measured 1000W load from cold start, once it reaches temperature its <20W most of the time. Holes aligned perfectly with my bed. I bought the digital controller separately, and with a little handy soldering, it worked flawlessly. Shipped fairly quick too. There was some odor at first but it subsided after a day or two of use. Worth it.
J**E
I highly recommend this upgrade in combo with a solid state relay ...
Now we're talking! I can finally use all of the area on my S5 without worry of warping. Additionally, this thing heats up fast and hot enough for materials other than PLA. I highly recommend this upgrade in combo with a solid state relay and the latest Marlin Unified firmware from TH3D.
T**J
Works
Fast heating, needs solid state relay and firmware update. Center of heat bed stays at the set temperature, edge of the bed is few degrees lower (bed not yet insulated).Fast delivery when using expedited shipping.
T**T
Too easy
Works great. Easy to install. I’m running it with a solid state relay that the printer board turns on and off. Heats up pretty fast and evenly.
Trustpilot
1 month ago
2 days ago
