Black Heat Resistant Thin Silicone Rubber Gasket Sheet Adhesive Back,1/25 by 12 by 12 inch

The rubber seal on my front load washer had a tear that caused it to leak, I purchased this as a temporary fix. It work well bur a minor adhesion problem so I used a super glue gel and clamped it for 24 hours and everything was fine.I moving in April and I will have a much larger laundry room so I can replace the seal with a new one.

Picture on website shows it lying flat. It came in a roll. Having a hard time getting it flat so I can cut shapes out of it.

The product itself is great, but it came so tightly rolled that the backing slided a quarter inch on one edge, and when I flattened it another section of the backing lifted, exposing the sticky side to dust and dirt so it may lose stickiness.

The grip on this stuff is amazing, it is so good I thought that maybe it was magnetic, it is not. I needed a solution for a product that I designed so that it wouldn't slip around when in use. When i went to amazon to look I didn't have high expectations, even when it arrived I was still skeptical that it would work that well, I could not have been more wrong. the grip was so amazing that I stuck the part to my refrigerator just being silly... it stayed. Simply amazed. At roughly 1mm thick it is perfect for what I need.

The material is somewhat tacky so it prevents smooth surfaces from skidding. That is why I purchased the item, and I can say that it works well for this purpose.I do not know what it is made of, but I have reason to believe this is not normal silicone material. It does not seem very durable, as I was able to leave a scratch mark with my fingernail.The material ships in a roll and does not flatten very well. Consequently, the adhesive may have a difficult time because the rubber wants to roll back up.Finally, the material emits an extremely strong chemical odor that lingers for days, and may cause breathing difficulty in sensitive persons.

The sheet is a bit thicker than presumed but still works great. I cut rectangular pieces and stuck those on two of my wireless phone chargers. Those are hard plastic and incredibly slippery. Set a glass backed smartphone on them to charge and risk any bump or motion to send it slipping off.It has not affected the charging capability even with a case on my phone. I plan on using it for other similar situations.Better safe than sorry. I paid more for this phone than my first car and I really try to take care of my stuff.

I didn't even know they made such a product, but recently I ordered a product to hold my cell phone but it slid around too much with the mall rubber feet the stand had, so I thought if there is such a product as a sheet of silicone with adhesive on one side to stick it to the base of the stand, that would hold the stand in place and still be able to move it - otherwise I'd have to use glue or double-sided tape. A piece of silicone the size of the base worked perfectly. And then found a few more uses for it.

not a fan of it being rolled up