Phone Loops: Non-Elastic Phone Grip, Phone Strap, Phone Holder for Hand - Small, Light and Discreet Phone Loop Cell Phone Holder for Hand - Phone Finger Holder

Works great, just what I was looking for. When on the phone I can easily slip my hand under the strap and do not have to worry about dropping my phone. Fits perfectly under the phone cover and it not bulky when I put the phone in my pocket or pocketbook.

Used with a Galaxy S9+ and a clear case. I love it! Hold your phone for long periods without gripping it. You can put 2-3 fingers through it, or better, use thumb and forefinger (see photos), which puts the phone on the SIDE of your hand so you can see it without twisting your arm 90 degrees. Greatly reduces arm & hand fatigue, while making phone much harder to drop. This is not elastic, so you need to adjust it carefully before sticking the second end down. Stick first end, then pull second end snug across 2-3 fingers, and stick the second end. If you want to experiment, leave most of the paper on the second adhesive so you can just tack it down and try it. Then make a mark on the case, remove the rest of the paper and stick it down for good. I thought, as others have said, it's just an expensive piece of ribbon. But no, it's heavy-duty ribbon, and great adhesive, and you'd spend more on gas shopping around than this costs. Go for it! You'll like it. --KV5R

I was looking for something to replace my Pop Socket with so I could use wireless charging, and so I could hear/feel my phone buzz when I set it on my table at work. This looks like it will do the trick, because I was able to hear/feel my phone while it was on vibrate all day. I put it on so I could put two fingers in the loop, instead of one like the directions say to, and it feels a lot more secure. I'm able to hold my phone upside down without it falling off my fingers. Comfort wise, I use my first and middle finger in the loop, and then my ring finger rests below it, and my pinky is at the actual bottom of my phone, and I have noticed that my ring fingers start to cramp up and ache a little after a while, but comparatively I would get sore spots on my fingers where the plastic from the Pop Socket dug in. There is a little slack, unlike what is shown in the pictures, because of the room for my fingers. The tape feels strong and I'm not worried that it will come off. It was very easy to put on. I put it through one hole (fingerprint reader in my case) and stuck it down, put the other end through the charger hole and stuck it with tape until I got the "fit" the way I liked it. Then I stuck it down for real. I have seen reviews talking about it losing color at corners, and I have seen that too after two days. I got the loop in black, and it is not that the color is rubbing off, but that the ribbon is not woven with just the main color. Like mine the ribbon is woven with black showing, but white underneath. So when the ribbon is stretched around an edge, the other color shows through. I've seen this with other ribbon before. Not very attractive in my opinion, but not a deal breaker, and it's not noticable at first glance. Just wish the manufacturers had used ribbon that was woven with just the one color. I also thought about DIYing a phone loop from ribbon from the store because this really is a simple design, but I decided to buy this instead because I figured it would be better engineered/stronger. I believe that is the case, as it's industrial 3M adhesive and not just plain old Scotch double sided tape to keep it on. Plus the cost of tape + ribbon would be the same as just buying this. I would have rather paid $5 for this product because $10 feels a little sharp for a piece of ribbon and some nice adhesive. I don't know if it's repositionable, but I never have had good luck with repositioning any type of phone grip so I'd just assume it's not. Overall, I think it will do exactly what I need it to do, so I think it's pretty good. Very clever idea too.

First off, I may have missed it in the descriptions, but I expected this to have some elasticity to it. It didn't. I have an iPhone 14 Pro. Installation issues: - You have to run the loop through the camera hole and one of the speaker holes. On some cases, the speaker hole on the right will be longer than the one on the left to match the holes on the phone. If so, the loop is too big to run through the smaller hole so you will have to run it through the hole on the right. This might make a difference if you are right or left-handed and where you want the loop in position with your hand. - Once you have one side stuck on and it looped though, the directions say something to the extent to put your hand through the loop like you would hold your phone, pull the loop tight, then stick the other side down. So that's what I did! However, the issue with this is once you stick your phone in the case it pushes down on the loop A LOT causing more tension in the loop. Luckily, I had a MagSafe wallet attached when I attached the loop so I was able to remove the wallet when I wanted to use the loop. I love that this is super flat and doesn't get in the way of using any MagSafe accessories. However, since it loops through one of the speaker holes, my case wouldn't fit properly around my phone in that area. After a week or so I also noticed it stretching around the areas it was coming out of the case. This may have to do with it being so tight and me trying to use it with the wallet attached. After a couple of days, I ended up taking it off. It didn't leave any residue on the inside of my case. It may work better with other cases or other phone models. Great potential! Just needs more tweaks to be perfect!

I absolutely love the phone loop. This is my 3rd one over the last few years that I’ve bought. They are flat and very comfortable to put a few fingers in the loop or even one fingers. It’s great to help held your phone or even when you take selfies just slide your hand in the back and your good to selfie away;) It’s easy to install and the tape is super strong. I’ve adjusted the tape off the back a handful of times and the tape is still going strong. It’s such a simple invention but for sure a fantastic one.

I love the nearly invisible profile of this thing. It is not obstructive to my magnetic car mount, or my other gravity mount, or in my pocket or small bags. You can stick it on a bit of a custom angle snug enough (it is not elastic) that I don't need to really grip my hand at the device in any way while upright. Wireless charging works as long as your cover is compatible. I suggest putting the Loop on an angle to open the central charging area up and allow for better surface contact. (Though, per photo, in my case, the metal plate for my car mount prohibits my wireless charging options with the cover on.) It has supported my heavy Note20+ well for 8 months so far even after one re-sticking. Con: Though it is not waterproof so I don't just pop my cover and rinse like I used to, I have to wipe it down instead. Not that big of deal really, though some color can fade with usage of certain sanitizers. Because I looped the strap to the USB opening some USBs are a bit thick and takes a bit of working into the port. Could have done differently (speaker access) but works fine for me and my regular cables. But that is all I can think of as far as cons.

Won't stay tight, awkward, frays easy

I have the otterbox commuter phone case for s25 ultra. I have no lanyard hole and I do not use pop sockets or anything - due to wanting to use wireless charging. So I opted for this option. I have yet to take the stickers off - as im just trying it out for now to see how i like the positioning. So that being said. Yes, it does allow for wireless charging. Score. Since the commuter is a two part case, I added the loop on the side of the top cover. Which now almost doesnt fit back completely snug. That might change when I decide to take the stickers off. Its feels okay in my hand. Although I was looking for more of a safety net for my phone, as I'm clumsy as heck. Im not sure that this would save my phone from falling.

Article super

Great little product as described.

Útil y original

Straps are so much better and more subtle than Popsockets, highlighy recommend. The glue is 3m so good quality, you can take it on and off several times without issue

This is a very nice way to hold your phone. I wouldn't want those cups that limit the possibility to wear the phone in a jeans pocket. This doesn't change the form factor. Very nice.