MOOG K6535 Steering Idler Arm for Chevrolet Silverado 2500 HD

This went on my 2002 Silverado 2500 HD Duramax four-wheel-drive, with 265. 75. 16, BF good rich all terrain TA/KOs. I wish people would put their vehicle information when they’re writing reviews. This idler arm is a direct fit. Installed it in about two hours, kind of hard to get to. Had to use a puller on it. Rather on the old one to get it off. Was significantly easier than the Pitman arm! After I replace this and the Pitman arm the truck had absolute zero play in it. It’s only been a month, but now I can see how long my old ones were bad. At least two or three years maybe longer. After replacing them it’s like night and day. For an 18-year-old truck it drives like brand new, well, almost!

Fit Perfect on a 2003 Hummer H2. I expect it to get some surface rust but the price was right and after an alignment the steering slop is mostly gone.

Good quality moog part. Includes the grease fitting, nut and split pin. Installed fine no problems I'm sure it will last as long as you keep it greased.

No problems so far

What I needed

Worked great. Perfect fit. Great deal!

I have a 2006 Chevy Silverado 2500HD 6.6l CCSB 4x4, These trucks are hard on suspension and chassis parts, idler arms and pitman arms wear out in as little as 5k miles if using aftermarket wheels with larger tires and more offset. Moog parts are great because they are less expensive than ACDelco and are heaver duty. There is also a support kit made by cognito motorsports that aides these parts in extended life. The Idler arm is in a difficult position to grease as needed, so I recommend adding the remote grease hose and fitting from Moog.

Purchased this along with other quality Moog front end parts for my Yukon 2500 (4X4 w/6 liter). Amazon has the best price & with the Prime shipping you can't go wrong! This Idler Arm is very simple to change - took all of 45 minutes to assemble & switch out. Would definitelty buy again!

I installed the Tie Rods (both ends), Pitman Arm, Idler Arm, and Idler Arm bracket on my 2006 Duramax. It was a big job, but I was able to accomplish having never done it before. The Moog parts are excellent and all fit to factory specs. You can review my video on the install on Youtube. Just look up my username and you shall find. (Search for: How to replace idler arm, pitman arm and tierods on a 2006 Duramax)

Solidly built

Strong part, K6535 gmc idler arm.

Great product and direct fit.

Product as described and seems to be a worthy replacement in my 2007 GMC Sierra 2500HD SLE (classic). Price was great compared to local retailers that wanted almost double for the same mfg/part number.