Milwaukee 2471-20 M12 Cordless Lithium Ion 500 RPM Copper Pipe and Tubing Cutter Adjustable from 3/8" to 1†Diameters (Battery Not Included, Power Tool Only)

I have been a plumber for 43 years, I have carpal tunnel and cubicle tunnel from cutting copper by hand for all those years, these are a lifesaver. They’re very fast and do a great job. And I don’t have as much tingling in my hands any longer lol. I have my own plumbing business, going on 25 years. Only issue I find is that overtime the spring pressure weekends and it takes longer to cut. But at the low cost, I just buy a new one and throw the other one away.

Great time saver... also works in tight spaces. I purchased this to update my 100 yr old gravity heating sytem (mostly 3/4" copper with some 1" copper). No complaints. Saved my hands/wrists.

I do HVAC in a lot of boiler systems and zone panels some water heaters this thing turns a 20-minute copper cutting job into about a 5 minute copper cutting job if you cut a lot of copper this is definitely what you want I wish I could afford the bigger one cuz I do a lot of jobs where I need it too can't go wrong with Milwaukee but I will say if you cut a lot of 3/8 refrigeration lines or quarter inch lines this does not cut those sizes

Wonderful tool

Eficaz siempre la mejor herramienta

Item broke after only a few uses and seller was not helpful at all no refund, no warranty, no customer service just selling a product that will 100% break awful.

Work better than I expected

It cuts pipe quickly and clean. Only down side is that it jams sometimes and you have to back it up and go forward again

I buy this tool 2471-20 tool only from Amazon. This tool I received today. Very useless this tool. No LED light on top. no pressure on pipes. No good clean cutting. Very disappointed.

It is a Milwaukee that speaks for itself Gentlemen as an industrial plumber I use this every day believe you me it is a fantastic tool extremely fast cutting increases your productivity. The only problem I have with this tool and I'm an extremely lover of Milwaukee I run the M 12 series is that this tool will leave a small little burr at times depending on how straight you hold it and you have to send it off or will not fit inside the fittings the only thing that I dislike about this tool but the work around to that is and the save you headache is to grab the pipe and the tool and counter rotate as you cut the pipe i.e. rotate the pipe right to left rotate the tool left to right as it cuts and it leaves no burger but sometimes it well so expected. Extremely versatile tool I can cut pipe in the wall as long as there's enough room for the tool to go in if a pipe is 1 inch away from the drywall or wall I can slide that tool in their and cut it imagine getting a small little cutter and trying to twist it with your hand how long it would take it takes me two seconds to cut a pipe once again Milwaukee hits a homerun as expected if your plumber I highly recommend this tool for a couple of dollars for this tool how much is your time worth? If it saves you depending on how many cuts you do in an eight hour day one to two or three hours than it's well worth it if it makes your life easier why not?

Works good

Use this at least a couple of times a week on mostly 3/4" copper. Cuts easily, faster and saves our hands from arthritis! like others have said, it does leave a burr on the inside of the pipe, but an easy fix with the right tool. Currently using with the small M12 battery and I am charging after every 4 jobs or so.

Product is exactly as shown and works great