90 Degree Angle DC5.5x2.1mm Male to Female Adapter 5 Volt DC Barrel Power Jack Charging Cable Connector for Tablet (DC5.5x2.1mm)(2pack)

The adapter works perfectly

Wanted to run my 15V (positive center, 6.0mmx4.4mm barrel plug) Yamaha THR guitar amplifier off a PD power souce (PD battery or PD wall plug). There are USB-C to 5.5x2.1mm cables that allow different fixed voltage conversions from "PD" power sources to a fixed voltages (15V needed in my case). I found an excellent cable for this at Adafruit.com (USB Type C 3.1 PD to 5.5mm Barrel Jack Cable - 15V 5A Output (1.2m long with E-Mark) [ID:5451] = $7.95) and combined it with this adapter to fit my amps 6.0mm x 4.4mm with center pin input. Works perfect and much more reliable than another all-in-one cable made specifically by a 3rd party for the Yamaha amp to PD power.

These are excellent quality 5521 angle adapters. They have a solid inner barrel compared to some which have a "tuning fork" pin connection. They are a legit 2.1mm and NOT 2.5mm. (They will not fit a 5525 jack.) This is good as the connection is solid and reliable. The barrel length is 12mm before you hit the plastic. I've had some which are only 10mm, and, if you have equipment where the jack is even a little bit recessed, those fall out. These are plenty long and secure. My only comment is that if you EVER think you will need more than two, get these from Longdex (https://amzn.to/3TIpeno). They are 100% the exact same product just a four-pack for about a dollar and a half more. Those also come in a variety of other sizes, too, like these zdyCGTime angle adapters.

Bought these for my guitar pedalboard. A 90° angle before the plug adds stability. The walls on these are pretty thick so as you can see I shaved them down to size. Added some electrical tape to make up for some lost insulation. They work and fit great now.

This helped with a replacement power supply where the barrel connector was longer than the original.

they work well on C Crane table radio. I broke the end of my AC adaptor which plugged in straight out of radio so I bought a new AC adaptor and a set of these adaptors for my 2 radios and never had another problem.

Rearranged my garage slightly, and discovered that there was not room for a 12V power wire to make a nice gentle curve. Using this right angle connector fixed the problem in 3 seconds -- much better than rerouting the wire or any other solution. .......... The plumber who installed the water softener in my house did a poor job. He cut a pipe to the wrong length it cracked. I also hated to location of the tank because it stood about 2 feet out from the corner. I replaced the resin, fixed the pipe, and moved the tank into the corner where I strapped it to both walls (in California Earthquake Straps are a reasonable precaution). Unfortunately, in this new location, the tank is close to the junction box where the power and control wires from my tankless water heater enter the wall (on the way to my UPS and wifi router, respectively). Got right angle connectors for both the 12V cable and the ethernet cable, and VOILA! no more problem. :-)

Was not the correct ones for my needs but they are great quality. Read the details and make sure before you order. Lol

Received in 1.5 days after ordering, and gave it a quick test. It works with traditional Thinkpad models around 2011, including X201, T520 etc. To repair the power adapter, I just soldered a common 5.5x2.1 male connector (like the one used for WD external hard drives) to the broken Thinkpad wire. The soldered connector fits the female connector here. It may be the cheapest repair, and the price for each unit ($5) is not too expensive at Amazon (I meant it is not cheaper craps from ebay).

Tutto bene 👍

Works well, but causes a slight loss in voltage due to increased resistance.

Necesitaba 90º en un conector. El único problema es pagar por dos y el segundo no me tiene utilidad.

These are of good quality and worked perfectly for what I needed.