LivTee Truck Tailgate Light Bar 60" LED Strip with Red Running Brake White Reverse Red Turning Signals Lights, Car Truck Accessories for Men - IP68 Waterproof

Good quality. Easy to install and works as described.

Easy to install, Very bright, I like the back up lights too! Make sure you use some kind of cleaner on whatever you stick it too, Also the instructions don't tell you which side is left or right. The wires go out the right side, The pig tail is also too short, I had a female trailer wire harness and used it to hard wired it to the trailer wire bundle. I also didn't like putting it on my tailgate, So I installed it on the top lip of my bumper. It's tucked up behind the bottom of the tailgate. Looks good, And is somewhat hidden.

Product it's self is great. However the only issue i have with it is that the wire is located on the right side of the vehicle once the strip is installed the proper way. With that being said after installing the strip you have to run the wire back to the left side of the vehicle to plug into the 4 wire plug. Would have been better if the wire was located on the left side of the strip. I could have used a out another inch of slack to plug it in. Maybe if you buy this product install it with the wire on the left side of the back of the vehicle and cut and switch the wires for the turn signals

What can I say. Bought back in Feb. 2020 and still work. All LEDs still work and still intact. never thought they would last this long. Bright easy to see even I daytime. Been complimented on several times. I have them on a 96 GMC Sierra.

This item is just as advertised. Easy to install. Perfectly functional, gr8 looking, and looks really gr8 from behind at night on the highway. I had an occasion to ride in a car behind my 2008 Dodge Ram 1500 being driven by someone else at night, on the highway and I was thrilled with the light strip. I would buy this product again if needed and that is the highest rating I can give any product.

Easy install once tailgate was removed make sure u plug them in before you attach them to make.sure your blinkers are right plug and play worked fine used a wiring tap to the reverse light make sure tail gate is clean and warm before attach

Made the mistake of buying this, it fits nicely but once installed it causes many problems with the vehicle lighting and factory vehicles electronics Example is the vehicle brake assist system and programming systems! Can’t even return the item now for credit!! Not advisory purchase!!

So far happy with it. Only thing is where my plug is for the lights is on one side of my bumper and the wires are on the opposite end where left turn would illuminate the right side of the light bar. Quick fix was swap the green and yellow lines to have it work cohesively and operate as functional. Reverse lights bright as well as brake and turn signals. Good product, depending on application may need slight alterations.

This look great for two weeks, but now it is full of condensation. How can I get this condensation out?

Rien a dire tres bien fais

This set is non sequentional, Lights stay solid. I should have received the amber turn signals but received the red ones. Not going to try to excahange it because the work well. However only one function at a time works. But if you brake and signal these both work at the same time. The plig is on the wrong side, So you either have to cut and switch the wires or a simple fix was to buy an Male to Female plug for the four pin. I had posted a video on how the work and look but because it shows my licence plate I had to remove it due to guidelines. (Even though plates are public).

Terrible product wiring wasn’t long enough and if I flipped it the other way so the wiring was long enough the turn signals were backwards!