AideTekBox-All 72 Empty Enclosure Box SMT SMT Components Organizer Labels

I'm probably the minority here but I actually use this to hold decently sized amounts of watercolor in each well.Pros: perfect amount of room in each well to hold paint. I found other cases had cells that were unnecessary large. This saves paint. Especially if it's your travel caseThis is a very conveniently sized case. Because the cells are so much smaller than others, you can fit WAY MORE paints and still have a decent size. I modified mine to take the top of the case off. It really doesn't need it in my opinion because the tops to the cells do an amazing job keeping closed anyway. I've never had a top open while traveling, etc. to take the top off is very simple, just pull the pin out of the hinge. and it can be put back on if you change your mind.Individual lids for each cell. Essential for not getting your paint cells mixed up or having all your paints fall out if you drop it, etc. I just find it nice to open the cells to the paint colors that I'm using and close them as I go. Other cases, I had to open the whole thing to access the paints and I've spilled them like that.With my modification with no lid, it's super easy to access a paint. I don't have to open the top then open the cell. Also all the cells are on the board instead of removable which I didn't like with one of the cases I tested because it was too clumbersome when opening and closing cells.I want to say it's 90% air proof. I tested this case with acrylics and even though it dried up after weeks/months, it took the longest out of the other cases I tested. (Good thing) So good in fact that I have to leave the tops off for the watercolors to dry them out before I close them.Cons: This isn't really a con because I haven't found a case better than this one regarding airtightness. But if there were room for improvement I'd say it would be this. If I don't fully dry out the watercolors or use acrylic paint, when I flip the case on its side or upside down, the paint in adjacent cells will meet where the tops for their cells are. The cells themselves don't mix and the paint doesn't spill out but it's a slight nuisance because it may dirty your paints a little. The runnier the paint the more of a mess it creates. My acrylic paint traveled to the cracks of about 6 tops. See the picture I've attached. Not fully getting into the cells and not fully spilling out. This is the most leakproof case I've seen so far, but if you fill it with water and flip it upside down, it will dribble out. I wouldn't use it for anything runnier than acrylics. Like inks, etc.Overall, out of all the cases I've tested, this is by far the best. I've attached a picture. The top two rows are dried watercolors and the bottom row is acrylic. I sometimes use the other cells to mix colors as I'm painting. 5/5 would recommend.

beaders beware: I laughed when I opened the box and realized this thing is tiny! A bit larger than the size of a hardcover novel. with 72 storage ports, you can imagine there isn't room for much.BUT, I do like it a lot. I left for a trip the day later and was able to throw it in my carry on with all the beads i needed.I use a lot of 11's and 2mm beads, but if you use anything larger, opt for something else.

This is a half populated case. Top half is simply missing the little holders. This means it is twice as thick as it needs to be.

It was difficult to get out the the leftover rhinestones from the case.

It is what it says. I was quite disappointed to see how small the compartments were, but it is my own fault for not paying close attention. Pretty much the compartment will fit a single component. Meaning exactly 1 capacitor or 1 resistor or 1 led or 1 357 battery (like the size in laser pointers)I'm not sure who the intended consumer of this is supposed to be.

This is the perfect organizer for my Swarovski Crystals. I’m a nail tech and was having so much trouble trying to find an organizer. This is perfect! I can open each individual spot without having to take out a jar and unscrew a cap. The last I had was adjustable and the crystals spilled into all the other spots! .I just ordered the 144 for the rest of them! Probably will try to jazz up the cover a bit with some contact paper or something.

I'm using it for nail art decorations. The pieces I'm organizing are very small, with this each has it's own compartment, and the small square space on top of each compartment which is made to use with the labels provided worked out perfectly for me to glue a sample of what is in each compartment. So I can see at a glance what I'm looking for. Love it! It would work for anyone wanting to organize and easily find small items.

I bought this to put my DIY Diamond Drill Beads in. It popped up as a suggestion. Definately not for that! Too small and you can't remove the compartments. Not sure what you could use it for. It's too tiny!

I had to return this (well, I got a refund) , the whole case was warped like a banana all round (see pics)I believe it's at the moulding stage it's happened, pulled out too quick or cooled down too fast or too slow, or maybe it's the complexity of the internals that add bias/stress at the cooling stage.Either way if they could avoid the problem and the casing actually met at all edges I'd have a few.Two stars rather than one because it's a nice idea , just poorly/cheaply executed at manufacture.