MAX Professional 7777 Blow Off Freeze Spray Electronic Component Cooler, FR-777-777 (10 oz)

This MAX Professional "Blow Off Freeze Spray" is a great tool for trouble shooting electronic circuit boards and components. We use this to identify chips and transistor that fail when they get too hot buy letting the circuits heat up to the point that the device fails and then using this spray on individual components. When the faulty component is sprayed the circuit will start to work working properly, so that identifies which one needs to be replaced.Using this is easy with the included "straw" to direct the spray where needed and there isn't any film or residue to clean up. A little if this goes a long way, as a short squirt is usually enough to get the needed results.This works well for my needs, highly recommended!CFH

I really like using it ... but you need to know what you are doing to use it. It has various uses and I am not trying to freeze the delicate parts in the Electric shaver. I use very short blasts from a distance away from the shover head. I clean both sides of the shaver head and then rinse in warm water after it has warmed up a bit. Makes very short work of cleaning the head of the shaver. READ THE WARNING LABLE ON THE FREEZE CAN!

I read somewhere that freeze spray is useful for 3D printing; to remove models easily from the build plate. It definitely works. Take a corner of a model and shoot a few squirts of the freeze spray and you can definitely get a spatula under the model. In some cases, the model just pops right off of the PEI. Definitely leaves a tiny bit of residue, be sure to clear the build plate with some alcohol afterwards to be safe.

Removes some skin tags/warts first try. Some need additional application. It is tetrafluoroethane, so it freezes down to -65F. It is best to mask off adjacent skin to limit freezing to only skin defect. I used vinyl flashing with holes of various sizes punched in it to do the masking. I have since ordered the following Amazon product to do the masking:Medical Skin Tag and Wart Removal Nozzle Speculum for Target Freezing of Skin Warts - 2mm, 3mm, 4mm and 5mm Sizes. The vidio in the comments about how to attach a nozzle to the spray tube to enable one hand usage of spray. That is important for skin defects in locations that are difficult to reach with two hands.

I had a wart on my neck below and to the left of my chin. Think headlight. I was tired of it. I bought this spray and it worked! I used a drinking straw, cut to about 6", pressed tight against the wart, and sprayed a couple shots on Monday. It turned a little darker brown over the course of the week, and it seemed to be getting smaller. The following Monday I did it again. It fell off on Thursday. Yay! Do be careful with the spray, as it is REALLY cold and it hurts if you spray too much. I was a bit too ambitious on the 2nd try and I got some on the surrounding skin. It's healing, but I need to use makeup because it's still a little red.

I used this to try to help remove a dent from my refridgerator. Tried heating it up and spraying with this spray to cool it down quickly. The dent is in the corner, but it did lessen it a bit. Product worked well, as expected!

I worked 37 years for FAA in the electronics field and we always had circuit freeze available. I fixed many problems at work and at home just by spraying some components that got noisy when they warmed up. Works great

Can's seal was broken although it seemed full. Was missing the spray tube.