MEUS RACING Motor Pinion Gear Puller Remover for Motors with 1.5 2.0 3.0mm Shaft of SCX24 TRX4M FMS18 etc. RC Tool

When I bought this, I did not realize it was for an RC. I needed a specialty tool for a different application. I went with the dimensions and size for my application. It worked better than I could hope for. Just so you know I used this on a 1995 Ford F150 clutch master cylinder. It pushed out the spring pin that holds the pressure line in place. Great quality tool.

It works only on motors that actually fit between the two sides if its any bigger than its useless KP000

I've seen a lot of pinion pullers but these ones are hands down the best the quality is Top Notch the Precision is top-notch and the best part they'll install the pinion as well as remove it!

The only issue I had was the punches will want to bend if you are not careful. Take your time and line everything up, it will take more than one try. Once everything is lined up correctly it should come apart smoothly

This one works, while the small brass ones crack. I know this bc I bought a brass pinion puller but it was made too thin and snapped. This MEUS puller is strong like bull! 🐂

I used this to remove and press on a new pinion gear on my Mofo Nanabeast motor. I found it super easy to use and had the job completed in less than 5 minutes from the time I opened the box. Now I can play around with brushless motor gearing options with pressed on pinion gears.

Handy tool for my RC tool bag.

This tool is not for all motor and pinion removal. the "handle" can not handle high torque at all. the plate that holds the motor shaft slides around until you finally get the pin to set on the motor shaft.