Official Anet A8 Replacement Mainboard - For Anet A8 3D Printer With Auto-Levelling

The good: Bought this is a drop in replacement for my printer after the bed thermistor connector shorted out on the old one, and was able to flash it and it worked as expected, initially. Anet has replaced two of the green power connectors with screw terminals which look less likely to burst into flame. The bad: The Y endstop connection on the board stopped working after less than a month.

Is not the same board the upgraded board displayed is v.1.0 the old board v1.5 is what I receved.with screws for power and for hot bed junky board.this picture is what was purchased.

Quality replacement part, solved an extruder malfunction.

My original board that came with the printer could be upgraded with the marlin firmware, but this one you cant upload the firmware, after contacting the seller, they said that marlin is not supported. which is not true for the other boards,so if you are planning on buying this board and upgrade the firmware then its not the board for you

Item as posted, direct replacement. Runs fine with all the firmware.