ACDelco Silver 18A1095A Front Disc Brake Rotor

Exact fit. I have used AC Delco brake rotors before and they are definitely made of quality steel.No more vibration when braking at highway speeds.

Good product, not OEM but one third the cost. AC Delco makes good rotors. Have them on both rear and front now, no issues so far. Would recommend considering them.

Perfect fit

Very good product

I’m here to write this review so I guess they are doing the job!!

Perfect fit, installed in 30 minutes.

I will preface this review by stating that I am an ASE certified Master Automobile technician with more than 20 years of professional experience. It has been my practice to install only genuine OE parts but at times they can be very cost prohibitive. I installed these rotors as replacements for the original equipment rotors on my MDX. Even though I was not experiencing any vibration or noise and the rotors were still within the acceptable range for minimum thickness I figured that at 96K miles I might as well replace everything. The rotors looked fine out of the box and fit as expected. I also installed Bendix RD793 pads at the same time. As usual, all hardware and slides were cleaned and lubed. Wheels were re-installed and torqued to specification. I performed the recommended pad bedding procedure and drove no different than I have before (no massive loads, no towing, no excessive long downhills). I did notice that it seemed as if it now required more braking force to slow/stop the vehicle but i attributed that to pads needing additional time to properly bed. I first noticed the warping after about 4k miles. Upon inspection I found no obvious signs of overheating and pad material transfer as expected. I performed a lateral runout test and found the RF rotor had nearly .020" of runout!! This led me to the conclusion that the rotor likely had a minimal amount of variance right out of the box. This can only occurs if the rotor is manufactured incorrectly or it is stored improperly for an extended period of time. Needless to say, I was not impressed. I have since installed the Powerstop K2299 kit -http://www.amazon.com/gp/product/B005FL5EB4/ref=cm_cr_ryp_prd_ttl_sol_12 and have had zero issues. Much higher quality rotors and superior stopping power. For just a few dollars more it is a no-brainer.

Compared to my old rotors (warped also) that were at limit for machining l these are awesome so far. Installed couple days ago measured them all around to make sure machine thickness and they were same measurements all around. Would highly recommend at this time will update after some driving 283206 miles currently

Brakes work great now, good solid build and fit.

Paid extra because it states in the description that it has "Rust-preventative coating provides corrosion protection" but a day after installing, I noticed a lot of rust spots all over the rotors. Would not recommend this product.

I originally thought it was a bargin until I realized the price was for a single disk.There are better deals out there.I am satisfied with this product however. Installed 6 month ago.

Very expensive and can't return because its you who is paying for the return shipping and its very expensive.

Overall size is ok. But not the depth of the rotor.Returned to amazon.Matt