Garmin Cable grommet

Fits starlink cable perfectly

I needed a grommet to allow small tubing to come out from from a sound deadened cabinet in my office. PERFECT!

Simple and easy to install. Added some silicone to seal up the hole required to install my Starlink satellite.

These would have been perfect if they would fit a one inch hole. Had to send them back. But would use if they had large cable holes and a smaller diameter.

It fits

The short and sweet review is that this is a perfect solution for a weathertight through wall installation of the Startlink V2. Keep in mind that you will want to disconnect the cable from the dish and run in from the inside to the outside not from the outside it due to the connector shape. In my case after running the cable I sprayed expandable foam in the hole first (only a small amount) then put a bead of silicone around the grommet and pressed it in to the hole. Finally I added a thin line along the split in the grommet.

I like the fit and ease of use. This product works with either end of your Starlink cable. It provides a large enough cover for the exact size hole needed for the "wide" end of your Starlink cable. I am thoroughly pleased with it.

I like its simplicity and the instructions that come with the grommet. They come individually and a limit of 3 per order. What you can't find out until they are delivered is the size hole to drill for them if you want to get your application usable before they arrive. The size hole to drill is 1.25 in. (31.75 mm) - these are from the instruction sheet. Garmin was not able to answer this simple question.

Genuine Garmin part and packaging

hard to comment on a grommet

Very flexible and installs easily. I'm using it for a single speaker wire going from the back of a center channel speaker, through the wall and into the Amp below.

Worked for my application