UHMW Sheet 1/8" Thick New

I used this product to make slides for a custom kitchen table to allow the heavy 2 in thick maple top to slide open to accept a leaf. I ripped the sheets into strips on my table saw and countersunk screws to the steel I was using to support the slides. The material machined well and provides a low friction slide surface. It has worked great for my needs.

I spent a lot of time deciding what could help my heavy aluminum canoe slide over the rear crossbar of my aluminum rack. My solution was this somewhat expensive sheet of plastic. I pop riveted one edge then heated it with a heat gun to form it over the arch of the crossbar. While it was flexible I pop riveted the second edge and wrapped it tightly with rope for a couple of days in the hot sun. Great result. It lays smoothly and the aluminum gunnels of my very heavy old Grumman slide easily across it with no gouging. Loading this canoe is now a one-man job even for this old man. It's still not easy but I can do it again...look out trout!

I needed this for a little project. I didn't even know about such product until I saw a YouTube video for another use. I have enough left over that I'll probably attach this to my table saw fence. I'll definitely buy more.

I used this to cover the face of my cross cut sled, it works well. I bought the 1/8" thick sheet and maybe should have opted for the 1/4". The only issue I had was the screws pulled through the thin surface of the strip.

Great material at a favorable price. After installing a folding attic stairway and constructing an insulated raised sliding cover for the hatch, I found it a bit difficult to slide the cover open and closed. This material machines smoothly with a table saw, and the ripped strips were then screwed down on the 2 x 4 frame of the the opening. Presto, the cover now slides smooth and so easy my disabled sister can slide it with ease.

It was packed kinda haphazardly, but its a long add length of UHMW so there was no harm in the packaging. The material was straight (not warped). Working perfectly as a new "blade" surface for my snow shovel (durability against the concrete is great). Also used it for a few other rub strips around my shop. Excellent material at a good thickness (1/8").

i used this to create (2) super slick hard surfaces to reduce friction, where the slideout on my RV was draggingreally helped the extension and retraction of the slide out

Just as advertised. I cut mine into 1" strips and used them for drawer slides. Five foot long drawers slide smoothly.