Fosmon Fosmon (4 Pack) Single Gang Wall Plate, Brush Style Opening Passthrough Cable Plate with Low Voltage Mounting Bracket

Used this product to hide my wall mounted monitor power cords through the wall and under deck to power block. Very clean look. Very easy item to use anywhere on wall.

These were insanely easy to install. I just drilled four holes in each corner and cut the drywall to fit and voila. Less than five minutes to put in. They matched the plugs perfectly and look fantastic. I’d definitely buy again in the future if doing another tv install.

Already had precut a hold in the wall behind where a normal gang box would have been. Since there was no nearby stud this low voltage mounting bracket was exactly what was needed. Installation was easy, though instructions (small single 4" X 6" "User Manual") was not clear. First cut (not drill) hold in wall where a gang box normally would be. (No stud nearby in my case but gang box not necessary). In my case the cable(s) were already present so just feed them through the black bracket. Push the black bracket inside the hole so the outer edge against sheet rock. Then (not in instructions) you need to unscrew (the 2 tiny white screws) in the wall plate from the white part the cables pass through and feed them through that part, then use the provided screws to screw it into the black bracket. Finally screw the wall plate back on. The final picture in the instructions does not match the product - looks more like a ethernet port than a pass through.

Good quality and easy to fit

As my title says - when I read "2 pairs" - I assumed that the order would consist of two sets (i.e. 4). In any event, they are of excellent quality and I have since purchased another round for the 2nd Television install. One suggestion to Fosmon - a drywall cutting template would be a nice addition since using the bezel as a template is a bit awkward.