Chrome Bathroom Faucet Waterfall Single Handle Bathroom Sink Faucet with Metal Pop-up Drain, Bathroom Faucet One Hole or 3 Hole with Deck Plate

Beautiful and easy to install

I love this faucet!! It was easy to install and works great!!

installed the GENBONS matte black waterfall faucet for a single‑hole bathroom sink and appreciated how it upgraded the look—sleek, modern, and minimalistic. The waterfall flow adds a spa-like aesthetic touch whenever you use it

Inspected the faucet and will install later. Looks good and solid and the handle has a good positive feel to it. Finish is clean and consistent. No red flags. The only concern would be in the flat base connects well with the sink but it looks good. Packaging was solid and will do well kicking around a jobsite with no damage.

I purchased 4 of these black matte faucet and drains to update the look of my bathroom sinks. These look great and were very easy to install. Even though it didn’t call for it I would recommend using plumbers putty just above the conical washer and nut to help seal it better at the underneath side of the sink. Otherwise you will most likely continue to tighten it to stop water from dripping and feel like you might break it since it’s never a good idea to over tighten plastic parts. Once I used plumbers putty I tightened it a realistic amount and it instantly filled in any gaps much better than without using it. The pop up stopper works great. I tested it by filling the sink and it was still at the same level 24 hours later. That’s when I let the water run down the drain and then realized it was leaking around the drain pipe into my cabinet below and since I was leery of doing any more tightening on it that it would just be much easier to use the plumbers putty. After that all is good. I’m very pleased with this product.

Installed it 1 year ago & it still looks & acts brand new! When I clean it that is… I forgot how much more work black accessories are.

I purchased two faucets. One does not shut off completely and drips constantly. The supply lines with 3/8 inch female compression ends were too short to reach the supply valves at the bottom of my cabinet. The adapter fittings supplied, 3/8 inch male compression/half inch female pipe thread, do not fit standard US half inch supply lines which have a female end. A 3/8 inch male/half inch male adapter would have solved that problem. The supply line end with an O-ring that threads into the faucet came loose while tightening the 3/8 inch compression fitting on the other end and leaked when the water was turned on so you need to hold the crimp connection with pliers or vice grips without damaging it while you tighten the compression fitting. The tailpiece bottom washer leaked around the threads on the tailpiece on one of them no matter how tight it was. Plumbers putty is needed there but the instructions do not call for it. Both pop-up drain stoppers were too short for my sink as supplied and would not stay down. I had to back the brass drain basket out on its threads as far as I could and keep it secure and super glue the threads in that position.

The media could not be loaded. I got 2 of these in September 2024 when remodeling our guest bathroom. They looked great and worked wonderfully for 6 months… After 6 months the water doesn’t come out all the way across the faucet and it is bubbling along edge and the plug are both pealing. Very cheaply made. Now I have to replace both faucets and pay a plumber to reinstall new (better quality) faucets.