20 Sets Mini Micro Sh 1.0mm Jst 3-Pin Connector Plug Male with 150mm Cable & Female

These are a good match for the 3-pin JST connectors & cables that are used for the Raspberry Pi Pico Debugger (both the SWD and UART). They fit fine and are easy to connect. Note however that the color coding is reversed from the RPi cables - Instead of Yellow/Black/Orange they are Red/Black/Yellow.

Was able to replace my cpu fan on my ACEPC with this kit.

This is the right connector for the SWD debug connector on a Raspberry Pi Pico H. A tiny bit of insulation is removed from the bare wire ends. I couldn't strip any more off with my simple tools (they cut through the wire) but managed to solder them to wires whose other ends have breadboard connectors. I needed only one but mangled two while doing this so it's good that you get many in a pack.

I Connected it to the debug header on the RPI 5. TTL (red=TX) (black-GND)(Yellow=RX) The wire was good quality. Stripped easily and was easy to solder.

These are wired wrong as most servos and receivers have the black ground wire to the outside and not in the middle like these. After I pulled and swapped the red and black wires they worked fine.

Ordered these 3 pin connectors as spares for my ViFly Drone Finder (loud buzzer) for my FPV quadcopter. They fit in just fine for this particular buzzer. However, my original order that was received was the 2 pin JST connectors rather than the 3 pin that I requested. Contacted the seller, they were prompt in re-sending the order correctly this time, and now have the 3 pin connectors. Didn't even have to send back the wrong order. Thanks.

This is the connector on eachine trashcan for motors and led strip.

Good value, used only a couple so far but and they work well.

Be where plugs from Amazon are often wired in wrong order for servos and receiver. Red is usually Iin the middle. Also some power leads are incorrect and have destroyed equipment.

As expected not silicone wire.

High quality item.

The wire colours are messed up. The ground wire is black, the positive wire is red. In most of the RC connectors it has to be NEG-POS-SIG. What happened here. Same with many other manufacturers ....