Pair(2) Power Window Door Jamb Wiring Boots Z (Accordion) Style,4" Long 3/4 Hole Compatible with Chevy Bel Aire 150 210 ; Camaro ; Alfa Romeo

I took a chance and hoped these would work for a foxbody mustang, without measuring the hole. These are way too small for me, but I give them 5 stars because they will work fine for a smaller hole. Mustang hole is 1.75" btw. Not sure what these are. 1.25" maybe.

Used for an opening in a hatch back lift gate. Easy to install, used a 3/4” thru hole on sheet metal and it set in the groove nicely.

These were installed on a 70 Chevy pickup. There were 4 pairs of wire (Approximately 20 guage) run through them. It would be easier to figure out where to drill if I had them first but if they're offset around 2"-2 1/4" in height then they should still be long enough with a door all the way open.

Way smaller than I thought. That is a regular Bic lighter in the picture with it. I was hoping for something closer to what is in most door jams from the factory. Partly my fault for not reading the description closer. But honestly, I think the door jam boots in a smart car are bigger than this.

Good quality product , could have been a bit longer for my application.

works awesome for running 3 2/12-gauge speaker wires into my door panels. probably could run 4, very soft rubber, bends really easy, to the point where it doesn't hold its shape. when you run wires through, but it maintains a waterproof seal. 10/10 would buy again