The case is crafted out of two transparent layers and two red layers.Each layer is laser cut from high quality Acrylic and once stacked they securely contain a Raspberry Pi B+ from shorting out but maintaining a slim profile to show off the board while leaving the primary ports, accessible and safe. This Case has cutouts for the Camera and the display headers as well as a room to install a heat sink on the CPU. Weighing only 2oz the case is lightweight and ready to protect your Raspberry Pi B+. Held together by high quality black Nylon bolts and nuts that are far superior to metal bolts that will scratch surfaces you set them on. The bolts are easy to install and no tools required for assembly or disassembly. Rubber Feet are included to stop the case from sliding around on the surfaces it sits on. Note: The GPIO slot does not fit a IDE cable without filling down the bolts to make them D Shaped. You can also purchase a header extension at http://www.adafruit.com/product/1979.
Trustpilot
1 week ago
1 week ago
