ShurTech Tape ShapeTape FrogTape 1.81-inch x 25 yd-Chevron

Just what I needed

Great item

Nice idea. Expensive. It did rip off some emulsion which I would expect them to get right. Also the backing kept on getting stuck on the back of the tape and took ages to get off. The backing comes off in two halves Would be better if the wave had one straight edge and one wave edge. It would be very rare to want a wave both sides and you could simply use two pieces. All in all could do better at this price point.

Fantastic lines! Tends to peel a bit so we painted slow over them.

This tape is awesome. Have a partner ready to help you with the peel and stick backing. Mark on the walls where you want it to go and then have your partner help you line it up. Works great. The adhesive is lite. We taped over paint in less than 24 hours and it did not peel the fresh paint. You think that your paint is going to bleed through at the tops of the chevron pattern because the adhesive is so lite. It doesn't!

Strong enough to stay put, easy enough to pull off. Leaves no residue. Excellent product.

I bought this for an accent wall in my bathroom. I wish I'd been able to do more stripes. I ended up wasting about 9 of the 25 yards of tape that it came with because I applied it crooked. There isn't much tape for errors. It honestly worked better than I thought it would. It was a little difficult to apply straight but not much more so than regular masking tape. Just follow instructions. Slowly peel back the top part of the backing and apply on the wall as you go. When you've got the top half on the wall and you're satisfied with how straight it is, do the same thing with the bottom half. As you're applying on the wall use a straight edge tool(I used my debit card) and smooth out the tape, trying to leave behind no bubbles. Another tip, paint quickly! The first stripe I painted, I applied two coats of paint and then peeled off the tape when I was finished. Some paint peeled off with the tape and I had to go back with a tiny brush and clean my lines. Luckily it wasn't too bad. I didnt have that issue with the rest. Bleeding happens. Prepare for touch ups. Mark where you're going to put the tape and use a leveler. Be patient. If I can do it, I'm sure you can too.

I have an older house that has plaster walls with some texture and this worked great. I applied a lot of pressure to the edge as I applied it and then went back over the seam with the paint from the upper section per a recommendation I read when researching the product. The tape came off easily and did not pull any of the paint off that I could see. I had only a few small spots that needed touch up where I hadn't applied the paint as evenly as I should. Definitely would use this product again.