3D Carving Tapered Angle Ball Nose CNC Bit, 5.4 Degree nACo Coated Solid Carbide Router Bit, 1/16" Cutting Dia, 1/32" Radius, 1/4" Shank, 3" Overall Length, CNC Router Bits, CNC End Mill

My boyfriend has been using this bit for about a week now and is really happy with it. It is durable and accurate and a real steal for the price.

Pretty good little bit, but a little over priced for a not recognizable name brand bit. I had zero issues with this bit, and it seems pretty sharp. I ran it at 2000 mm/min with 12% step over and could easily have increased this. It did leave some fuzzys, but most bits do for me on Oak. I'd say it's a pretty decent quality end mill but a little over priced.

This is a good carving bit for moderately hard woods or plywood on the CNC. I used this in a trim router to detail carve out some lettering and it worked well.

This CNC bit cuts very cleanly and is great for 3D carving. The steep angle allows you to carve lots of detail in 3D and the finish it leaves is very nice and clean. I would recommend this bit for 3D carving CNC folks.

This is a good sharp bit, but not balanced. Just running and not cutting, the imbalance of the bit made my router table vibrate so that my collet wrenches moved slowly across the table. I even tried re-installing the bit in the collet to be sure that it was in correctly. Same vibration both times. The cut in cherry didn't burn and was smooth. I like the taper in the cut as a decorative element. In the picture with the end view of the piece of wood, this bit made the cut at the top of the picture.

I have gone almost exclusively to tapered ball nose bits for relieve carvings on my CNC. You can get the same detail with a straight ball nosed bit, but rough carving is usually needed to prevent the bit from breaking. With the tapered bits I can usually carve without a roughing pass since the bit is much stronger. So bits like this save a lot of machine time. They are well worth the extra cost. These bits are great and last a long time. I am very happy with the quality of this bit.

Really sharp and I have used them several times for some long time cuts and are still very sharp. Can not go wrong with these especially 3d carving on cnc.

Really nicely manufactured bit. Protected nicely by its own case. The shaft/shank is smooth, and the bit tapers to a nice point. The flutes are very well machined, no flaws at all. I just had time to run it in a rim router and it cuts well. For CNC work it should be extremely useful and it is inexpensive in case accidents happen.