KENT Gold Optima Gravity Water Purifier (11016) | UF Technology Based | Non-Electric & Chemical Free | Counter Top | 10L Storage | White

so nice product

Broken and leakage apart from that looks good

Water dripping very slowly. When I raised service request, was told that technician will visit. However the request was closed without any communication. This happened twice and then was told that for this filter no visit available, need to take machine to service centre.

Product good but cost should be under 1000 rs, normal plastic some other products 1000 is more after commotion

The media could not be loaded. The product is dispensing good quality of water. No doubt.RO is really making the water sweet in taste.Pros- good in this price range, easy to handle, easy to clean, easy to relocate any where, low maintenanceDrawback- As per the upper capacity of the tank, if you put water more than half of the tank, the carbon filter bulges up due to water. So, you can not put more than half tank water in above tank. E.g. if the upper tank is of 5 litres, you can only 2-2.5litres of water at a time. If you go beyond the carbon filter will come up and keep floating. So you have to wait to fill it full.Else all over feedback, its good

This is the first gravity water purifier that I have used. I bought it because the muncipal water supply is a bit muddy at times, though the water is soft. It works very well, but filling water and maintenance is a little tedious.Installation is easy and the water tastes very well. I did not notice any foul smells as described in other reviews. It could be because, I washed each part with soap and then drained water from the filter twice before I started using it.The problem with this filter is that the sediment filter on top gets clogged very easily and needs frequent washing. This could be because of the muddy water in my area as I mentioned above. Every time this happens, I need to remove the sediment filter set (2 of them), wash it and put it back. I need to do this, every 30 litres of water or so. Otherwise, the water just stays on the funnel and takes a long time to fill the top tank.Also I can never fully fill the top tank of the filter. The water flow decreases as the level of water in the top tank increases. This is the case even when the sediment filter is new and clean. As the sediment filter gets soiled, this becomes worse. So if the top tank is even 25% full, then the water stays on the funnel at the top of the sediment filter and I have wait for it to percolate down before filling more water. This is cumbersome. I wish I could just fill the top tank in one shot and it can take its own time to come down to the bottom tank.Other than this, everything works well. Maybe all gravity filters need this kind of maintenance. I'm not sure.I thought of models where the sediment filter might be below - so then I can just fill the top tank and forget about it. But the problem here is that if I need to clean the sediment filter then I'll have to remove the top tank and then remove and reattach the sediment filter.

Most useless item. No instructions to assemble. How to put the pieces togerher. Only making life difficult. Give assembled product or give cell no. Of serviceman who will assemble.

Not good if usage increase