SEA DOG WATER SPORTS Tubes of Repair PVC Glue for Inflatable Boat

Used on the bottom of my dingy, it's still there 6 months later, baking in the sun, no leaks. I'd use again.

Have used this to repair 3 holes. Seems to hold well and stop the leaks. There were no application instructions but I just followed some others online and it seemed to work well.

Really great deal for you get. Tons of patches and glue. Works great.

I accidentally stabbed a hole into my inflatable paddle board when adjusting my fins ( silly mistake I know) but this patched it right up! I followed the directions carefully ( I’ve seen people say this doesn’t work, follow the directions and it will) and it patched it perfectly. Within the next few days I took my paddle board out and I had a very successful and enjoyable 4 hour trip on the water; the patch continued and continues to hold up. I will say I put some gorilla waterproof sealing tape over the patch as an extra precaution but I think I would be okay without it. Definitely recommend this if you need to seal some type of inflatable.

This item is OK. Nice orange container. A few different PVC patches and 2 tubes of MEK glue with instructions. Kind of pricey for what it is.

Very durable

Did not include patches like photos described. Only came with glue and orange case. Either I did not receive all or the pieces or photos are rather deceptive. Delivery was quick and everything else was as expected just frustrating to have to go back and purchase the patches I thought were included.

Small enough and I ordered it to have it on my inflatable boat just incase if needed as a safety measure.

As expected. Thanks

Rien a dire

This kit worked perfectly on two holes that were both roughly 12mm in diameter in my inflatable boat. Cleaning the area to be glued with acetone (not supplied) is 100% essential, I also cleaned the patches supplied with the kit beforehand too. Apply a covering of the glue to both the area around the hole and the supplied patch, then wait 5 minutes before applying a second coating to each once more. 5 minutes after the second coat I then applied the patch over the hole, rubbing the two together with a blunt wooden straight edge. I then left the glue to cure for 48hrs before inflating the RIB (HD Quicksilver 3.5m) and it has held beautiful under load on rough seas. I recommend this product 👌 but acetone must be used pre-gluing in my opinion. I hope this helps 🙏

The butyl rubber that makes most kayaks and SUP's is not thin nor cheap so why buy a cheap thin rubber kit? I bought a used 2 place kayak, it wasn't cheap and it's designed for ocean use as well so the rubber is much thicker and can take a few runs across sharp rocks before it will puncture. So...when it came time to order a patch kit, I wasn't about to go cheap nor should you. The rubber patches are quite thick and the glue is also not a tire patch glue, it's designed for this specific application and I got 2 tubes within this tube. Not sure why but there is not carabiner hole or lanyard attached nor is there a place to do so, that was the only odd part about this. Overall the storage container isn't water tight, more water resistant so I've placed this is my waterbag when I go out kayaking. I'm happy with this decision and purchase, the right tool for the right need.

La colle marche très bien et on a le choix des couleurs