Rutland EZ Spread Stove Gasket Cement, High Temp Cement, Fiberglass & Metal Adhesive for Wood Stove Gaskets, Made in USA, Black, 2.3 Oz

Worked great as a quick fix

This stuff worked great. It is thinner than I expected, but worked good. I'm a 68 yr old gma, & If I can replace a door Gasket, anyone can. I chipped off the old cement after removing the old rope gasket. I used a flat head screw driver, & a metal brush to finish it off. I then wiped all the dust off the door with a wet rag. I rewet the gasket channel and squeezed the thinner than expected cement all around the channel. I then kinda made sure it was spread well, using my finger. I used the required 7/8 inch rope and started in the upper left area, going down, and placing tape to hold it in place as I went. When I completed the door, I had about a foot of the rope left. I cut it off, a tiny bet long, & stuck the two ends together with a little of the cement. The cement is black & it matched the black graphite rope I used. I forced the door shut to insure it was a good seal. Then opened it, left it open for an hour, then ran the pellet stove for about an hour. The next morning I ran it as usual. Perfect fit! Whole job took less than an hour, and that included vacuuming the stove out, & cleaning the door. I did this with the door one the stove, not removed,

I had to squeeze very hard to get the glue to come out at first. Then something plugging the opening shot out and more than I wanted came out. This happened intermittently the entire time. Cleanup was easy, and the gasket stuck well to the glued channel, so I think it is a success in the end.

Works well.

I've been using this to reattach gaskets in my wood stove for the last 30 years. Occasionally during the "warmer" months of November and April I'll burn low fires which sometimes results in liquid creosote running down the pipe and into the firebox, where it will cause the window/door gasket to stick to the box, causing the gasket to pull free. After a thorough cleaning of the channel, this will reattach the gasket every time.

Great oroduct

Had to cut the tube since the cement wad too thick to go through the spout. Made it tough to spread properly but seems to be holding well

It worked on my dad's wood burning stove. It was easy to use. The fiberglass rope stays in place.

耐火ボンドを購入するより、こちらの商品を購入した方がホンマ製作所の製品には合っていると思います。 硬化時間が少し掛かりますが、固まれば全く問題ありませんでした。 耐火ボンドの方が色々と大変でしたね。

He is holding well after two months use, so it is as advertised. Would buy again.

This works great

鋳造の薪ストーブには必需品ですが、すぐに固まってしまいます。

結論そこまでして、素人が薪ストーブ修理してを使わないし買い換えた方が早い💦