50 Pcs Black Cable Tie Base Saddle Type Mount Wire Holder, Cable Zip Ties with Self-Locking 6 Inch & 0.145 Inch,#8 x 0.6 Inch Deep Thread Pan Head Screws Black

These are plastic anchors with loops that screw into the wall but i am guessing that using command strips for a more temporary or removable feature is possible. I have various wires and cords for my entertainment setup and computers that are organized and run along the wall and for the price you can't beat these mounts. They do use zip ties to hold the cords to the wall so you can do various sizes depending on how long your zip ties are and how heavy the things you are mounting are.

excelente producto

These are fine for the price, but the screws are a bit iffy. If you are screwing into anything that's a bit dense like wood in my case, then you need to drill pilot holes. I had a few of the screw heads twist off when driving them into my desk, and that was with a pilot hole that was a little short.I would say these are generally fine, but keep the above in mind when purchasing.

I use the mounts under a train layout for wiring the power bus and the accessory bus. I planned to run the buses, tighten the bundle ties as always, and then any subsequent wires runs could be threaded through the tie or - the tie could be cut and a new one installed. It turned out that the multiple runs of wire are still light enough and the tie itself is rigid enough that wires/ties held in place after only running the tie through the slots in the mounts - as if they were there only temporarily. The process saved time and the hassle of buying additional ties. The ties remain in the "temp" mode with no plans to fully wrap them. The screws provided are ample for attaching the mounts on a 3/8" plywood.

I have had some that the zip ties were very brittle and broke very easily. These seem better made and not so brittle. Happy I purchased them.

Comes with screws. Zip ties are of good enough quality, they don’t break as you tighten them. Does the job

Used these ties to secure wiring in my RV. With the short screw provided it was easy to attach anywhere one was needed, and at any angle. The wire holders are of good quality and the holes large enough to make it easy to insert the zip tie. Was especially happy with the short, black screws. Just what I needed to face mount some electronics, which always seem to come in black, and with long screws. Good price considering all you get with this package.

THE SCREWS ARE TERRIBLEI purchased these in December for a video distribution project at a recording studio.They work fine, but there's a huge caveat:--- The screws' durability is one step above toothpicks ---I pre-drilled all my holes, and I still had about 25% of my screws break.I'll say it again:### Even with pre-drilled holes, a quarter of these screws snapped in half ###Read the one star reviews. Some people didn't pre-drill...and they didn't get anywhere with these things.I'm tempted to give two stars instead of three, but the saddles do their job well enough.See the photos; I know my way around a clean installation.This is not my best work, but it's where I used this product, so these are the pics.The only reason this isn't *perfect* is because there's only 12.5 inches between the rack and the mounting board (really tough to fit myself and a drill back there, up on a ladder), and I was on a tight schedule to complete the project.I have a similar project now in the same building on a different floor. I've ordered a different project this time, hopefully the screws are better--but I'm bringing reinforcements this time (no pun intended).smile.amazon.com/gp/product/B07J1GW4RB